|
170427-183250.JPG
|
|
161029-154158.jpgAdding more sealing wax
|
|
161029-133114.jpgAdding peel ply
|
|
161029-133125.jpgAdding peel ply
|
|
161029-143855.jpgAdding spiral feed tubes
|
|
161029-152540.jpgAdjusting the pump pressure
|
|
161028-133008.jpgAttaching the front bulkhead flange
|
|
161028-133115.jpgAttaching the front bulkhead flange
|
|
161029-153005a.jpgChecking for bridges
|
|
161029-143954.jpgCompleting feed system
|
|
161029-112618.jpgCutting core material
|
|
161029-141053.jpgCutting infusion mesh
|
|
161028-144514.jpgCutting the wing
|
|
161029-122850.jpgFinal view of core material
|
|
161028-151907.jpgFirst layer of carbon
|
|
161028-151917.jpgFirst layer of carbon
|
|
161029-141259.jpgFitting infusion mesh
|
|
161029-141330.jpgFitting infusion mesh
|
|
161029-133408.jpgFitting peel ply
|
|
161029-132655.jpgFitting the carbon
|
|
161029-110614.jpgInserting core material
|
|
161029-112840.jpgInserting core material
|
|
161029-113513.jpgInserting core material
|
|
161029-113859.jpgInserting core material
|
|
161029-145626.jpgLifting the bag onto the mould
|
|
161029-115446.jpgLining up the last piece of core material
|
|
161029-151552.jpgMaking a seal for the vacuum tube
|
|
161029-152207.jpgMost of the air gone...
|
|
161029-145021.jpgMould for top half of car
|
|
161029-145639.jpgMould in bag
|
|
161029-144819.jpgMould ready for bagging
|
|
161027-122543.jpgMr Dusty
|
|
161029-140751.jpgPeel ply layer complete
|
|
161029-151418.jpgPreparing the catch pot
|
|
161029-151637.jpgPump running, sucking out the air
|
|
161029-115953.jpgPutting in shuttering for the rear hatch
|
|
161029-150052.jpgReady to be sealed
|
|
161029-153348.jpgReady to infuse resin
|
|
161029-150259.jpgSealing the first end of the bag
|
|
161029-154143.jpgSealing the front hatch frame
|
|
161029-151232.jpgSealing the other end of the bag
|
|
161029-131125.jpgSecond layer of carbon
|
|
161029-154038.jpgShuttering for hatches in the top half mould
|
|
161029-145457.jpgStarting to bag bottom half mould
|
|
161028-130606.jpgTop half mould prepared
|
|
161029-114345.jpgTrimming core material
|
|
161029-134328.jpgTrimming peel ply
|
|
161029-131127.jpgTrimming the carbon
|
|
161029-152655.jpgUnder vacuum
|
|
161029-154638.jpgWaxing the back of the mould
|
|
|
|
|
|
|